STEP 6:

STEP 6:

The finally! now that you have everything fitting inside, powering up and looking appealing to you(not a requirement, but why do so much work if it looks like #$%&!). First off work from bottom to top. Solder your power supply to your switch and other cables. I have ran 3 lights so i will have parallel circuit of 3 negatives in and 3 positives out. connect these to the power supply and into the circuits. I used hot glue to hold them in their slots. and also hot glued the cicuit boards down. after eltrical taping all the open soldering points you can move up to the lights. First off plug them into your lower boards. and run the cables through your mid plate hole or slot. once you have them up to the next level place the plate down to cover the lower circuits. Now its time to glue or tape your back lights into place. I taped mine so that i could change them if they died on me. but well enough they aren't going to flop around. once they are down you have successfully made the box. I will post some pictures of the final look!